Holden / Ford Wagon Upper Tailgate Bailey Channel Seal

NEW Wagon Upper Tailgate Bailey Channel Seal to suit.

• Holden
• HD HR
• HK HT HG
• HQ HJ HX HZ
• Ford
• XR XT XW XY
• XA XB XC

These little buggers fit in the upper opening to seal the glass in the body and stop the car filling with fumes and sending you to sleep!

Please note: To fit this bailey channel into the upper opening, first make sure that all of the original bailey channel has been removed and cleaned, relieve the bailey channel in the corners by using a sharp knife and carefully cut through the top of the channel into the sides (not more than half way down) approximately 10 mm spacing's.

Tip: Place the channel along the opening to know were the curves start before cutting.

Glue where needed with contact adhesive to make sure the channel stays put, don't be in a hurry to install the channel.

If the ends on the original channeling are intact, these can be cut off and glued to the ends of the new channeling to seal the tailgate completely when the glass is up.

We also have for your tailgate;

• Brand new Tailgates - shipped Aust wide insured.
• Tonneau hooks and cleates
• Hinge bolts
• Lock rods or plunger kits
• Rubber seals
• Limiting cables
• Cable mounting bolts
• Rear bumperetts rubber stops

Thanks for looking and don't forget to check out all of our Restoration Essentials in our store.

All postal deliveries are with Aust Post eParcel with a unique Tracking number. Your parcel's tracking number will be sent to you via email on dispatch so you can keep an eye on your delivery.