Holden Wagon Tailgate Weather Strip Seal Commodore VB VC VH VK VL pinchweld

You are looking at a Holden Tailgate Seal to suit;

• Commodore VB VC VH VK VL
• Wagon all models
• Length = approx 4.1mtrs

FITTING
The opening edge must be cleaned of any dirt before fitting the pinch weld. Start by fitting the pinch weld with the flap of rubber facing out, at the lock striker (middle of the opening) and push on it around the opening until you get near the starting point, carefully cut the rubber and then the pinch weld with a sharp blade approximately 10mm longer and glue the ends together then push the pinch weld back on.
Hint: If the vehicle has been repainted you may have to adjust the striker in/down, so the tailgate seals all the way around on the boot/ tailgate. On sedans adjust the striker so the boot lid closes level with the ¬ panels.

Thanks for looking and don't forget to check out all of our Restoration Essentials in our store.

All postal deliveries are sent via Aust Post eParcel. Your parcel will have a unique tracking number which will be sent to you via email on dispatch so you can keep an eye on your delivery.