Holden Bonnet Moulding Chrome Trim + Fitting Clips HK HT HG mold

You are looking at a Holden Bonnet Moulding Chrome Trim and the mounting Clips to suit;

• HK HT HG
• Belmont Kingswood Premier Monaro Brougham
• Sedan Wagon Ute Panel Van
• Kit Includes:
  • Stainless steel bonnet moulding
  • 14x pop rivets
  • 14x moulding clips
  • 2x end clips with cup washers and screws

Hint: Make sure that the holes are clear before using a pop rivet gun to install re-install the rivets to the bonnet. Then push the clips onto the rivets using a sideways motion.
Install the end clips by sliding the clip into the moulding checking carefully against the bonnet to get the end clips lined up with the bonnet holes, with the moulding hooked under the edge of the clips push/roll the moulding until the moulding sits against bonnet edge
Fit the cup washers so the curve is facing away from the bonnet and then tighten the screw until the screw head sits against the washer.
Note: if the washers are placed with the cup into the screw head, damage to the moulding may result due to denting.

Thanks for looking and don't forget to check out all of our Restoration Essentials in our store.

All postal deliveries are sent via Aust Post eParcel. Your parcel will have a unique tracking number which will be sent to you via email on dispatch so you can keep an eye on your delivery.